MHF cross-cut saw

Sawing and milling technology

In sawing and milling technology, we offer standardised machines and systems with individual optional features and outfitting for a wide variety of materials. Special solutions for extremely thick or long workpieces, as well as extremely thin and short parts, can be realised.

Cross cut saws

Workpieces can be positioned automatically and the material is cut to length.

 

Travelling cross cut saws

A stream of board is cut continuously. The saw supporting bridge synchronizes with the board feed and cuts the board crosswise.

 

Diagonal saws

Double diagonal saw with scorers in throughfeed

 

Flying saws

Continuous cuts separate for example laminated strips at the joint

 

Centre cut saws / Split saws

Panel-shaped materials are split continuously in throughfeed.

 

Panel-Sizing Saws

The MHF Panel-Sizing Saw in gantry design offers individual sizing of large panels with a package height of up to 165 mm featuring a high cutting performance and low space requirement as lengthwise and crosswise cuts are combined in one system. The saw blade can be swivelled by 270 degrees via a rotary tube and all cuts are made automatically one after another. The saw table with individually lifting transport belts, over which the boards are moved back and forth, enables symmetrical and offset cutting patterns.

 

Dividing saws

Parallel cuts divide boards into pieces of preselected sizes.

 

Double end tenoners

Video

We use third-party providers (YouTube) to embed this content. When accessed, personal data may be shared with these third parties. To view this content, you must therefore give consent.

   more information

Boards are processed at longitudinal and transverse edges. Undercutting scoring saws, moulders and sawing units can be combined.

 

Milling systems

Stationary and continuously operating milling systems

 

Video

Groove Cutting System

We use third-party providers (YouTube) to embed this content. When accessed, personal data may be shared with these third parties. To view this content, you must therefore give consent.

   more information

The system cuts up to four grooves simultaneously in one throughput into doors, door blanks or HDF/ MDF/chipboards and grinds off possible protrusions of the resulting contour in a further processing step. The components can be processed in longitudinal and transverse throughput.

Double-end tenoner

We use third-party providers (YouTube) to embed this content. When accessed, personal data may be shared with these third parties. To view this content, you must therefore give consent.

   more information
 

Address

MHF GmbH
Maschinen-Handel-Fertigung
Gewerbestraße 17–19
33397 Rietberg-Mastholte
Germany

Contact

Phone: +49 2944 9723-0
Fax: +49 2944 9723-99
Write e-mail